Product information - Jemflo and a+.

Jemflo and A+ are products of Jem Australia.

They are the result of more than a decade of research, development and use across a broad range of applications.

Jemflo and A+ are each a valve device that controls the flow of water.

They are not water ‘restrictors’.

Jemflo and A+ suit all brands of taps, including most types of single lever shower taps. These two Jem Australia products are simple, yet highly effective.

They work on the same principle.

They consist of a series of fixed orifice, intra-faucet flow controllers that are installed into any tap seat.

Jemflo is threaded into the body of the tap.

A+ is held in place by the body of the tap itself - enabling a less complex installation.

A range of Jem Australia flow controllers can be selected to provide the required flow rate at the available system dynamic pressure.

They provide a high pressure drop across each tap, so that the pressures entering the breeching piece from the hot tap and the cold tap are almost equal.


Go To Top

 

A range of Jem Australia flow controllers can be selected to provide the required flow rate at the available system dynamic pressure.


The resultant dynamic pressure in the mixing tube is sufficient to overcome the frictional losses, at the determined flow-rate.

In the case of a shower especially, it still provides a good terminal velocity at the shower head. It enables the shower head to perform at its optimal level.

Because there is a large pressure difference between the hot and cold system dynamic pressures and the pressure in the breeching piece - any changes in either of the system dynamic pressures will have little or no effect on the hot to cold flow rate ratio of the shower with Jem Australia products. Jemflo and A+ suit all brands of taps, including most types of single lever shower taps.